Shenzhen Rogin Medical Co., Ltd
Shenzhen Rogin Medical Co., Ltd Professional Manufacturer and supplier of dental instruments
Add to Cart
High Speed Wrench Type Handpieces Air Turbine Dental Handpieces with Mini Head
(Same as Pana Air)
Quick Detail :
1. Mini ,Standard or Torque Head
2. Cartridge for Handpiece
3. Key Type ( 4 or 2 holes )
4. Turn Smooth, Low Noise
5. Use Best Bearing, Long Durability
6. Air pressure: 0.2 - 0.24 Mpa
7. Rotation Speed : >=360krpm ( Standard )
>=300krpm ( Torque Head )
8. Chuck Type : Push Button or Wrench
9. Bur applicable : φ 1.59 mm ~ φ 1.6 mm * 21 mm ~ 23 mm (diameter * length)
10. Noise : <=60db
Specifications :
| 1. Fucation : 3 water spray / Single water spray |
| 2.Bur applicable: diameter 1.59~diameter 1.6mm*21mm ~ 23mm ( diameter * length ) |
| 3.Water pressure: 2.2~2.7kgf |
| 4.Turns speed : 350, 000~400, 000 rpm |
Description :
1. The need to use a clean , dry , oil-free air compressors for medical use
2. The air pressure between 2.3-2.8kgf / cm2
3. Place the adapter with quick connector at the bottom of a combination of dental handpieces , and confirm that the card lock fixed
4. Press the pedal , handpiece operation and examine whether the normal operation of the spray head . If everything is normal, you can start using the handpiece .
After each patient use , maintenance should be done as follows:
1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate
2. Use a metal needle to clean the spray holes and fumaroles
Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle
3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )
4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom
5. The handpiece with quick connector combination ( first determine the water switch is turned off )
6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )
7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain
8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization
